1958-62 Corvette Complete Rack & Pinion Kit

Part Number: 8011530

Leadtime Estimate if Not in Stock
Will Call with Lead Time
US$2,782.00

Status: Preorder

KT (1)

Description

Description

1958-62 Corvette Power Rack & Pinion Kit w/o Column

This is a complete kit that starts with a rear steer center take off style rack & pinion made to match the stock suspension of the '58-'62 Corvette. The rack is mounted to a one piece bracket that mounts to the stock motor mounts. The kit does clear the z-bar and 4-speed linkage and this kit works on small block motor cars with stock manifolds or shorty headers. Other headers may work with modification.

Everything that you need is included minus the steering column. The shaft kits use three u-joints and a support bearing. This connects up with a new Ididit retrofit column. You must use the column to use this kit!  Floor Bracket and Gasket are included. A pump kit with bracket to mount to the block is included which comes with a remote reservoir, single V-groove pulley and lines.

Kit Includes:

  • Rack & Pinion
  • Mounting Bracket
  • Mounting Hardware
  • Steering Shaft Kit
  • Pump & Line Kit

Features:

  • Pinion Type / Size: 17mm DD GM
  • Amount of Travel: 6"
  • Turns Lock to Lock: 2.5 - 2.75 Turns
  • Pressure Port Size: 18mm - 6AN Banjo (Lower)
  • Return Port Size: 16mm - 6AN Banjo (Upper)
  • Pump Required: Matched to Gear
  • Inner End Threads: 14mm x 1.5
  • Outer End threads: 8020940

Note: An Ididit retrofit column is needed for this kit to work. If you don't have one please order kit 8012420.

Prop 65 Warning

Prop 65 Warning

WARNINGATTENTION CALIFORNIA RESIDENTS:
WARNING: This store sells products that may contain chemicals which are known to the State of California to cause cancer, birth defects, or other reproductive harm. By ordering products for delivery into California, you acknowledge that you have received this warning. Please feel free to contact us should you have any questions. For more information, go to www.P65Warnings.ca.gov.
To top